Hornet 2 PC software

飞行参数-01
After installing the software on your PC you may connect to the Hornet 2 using the included Micro USB cable. The Hornet 2 PC software allows you to set Flight Parameters and upgrade the Software.

①Menu bar
②Aircraft Flight Attitude Bar to monitor Pitch, Yaw, Bank angles and other key aircraft information.
③LED Configuration Bar - Verify aircraft LED status or Set LEDs to Breath or Rotation Modes.
④Aircraft Configuration Bar is used to adjust the operating parameters of the aircraft.
⑤Connection Bar can be used to update the aircraft and remote controller configurations after they are connected.
⑥Horizontal Calibration,Parameter Save,Read and Default
遥控器-01
Operate Mode: Set the left hand throttle or right hand throttle control mode.

Remote Controller Calibration:Click to enter remote controller calibration,all 3 LEDs will flash green,Do not move the stick and wheel until all the 3 LEDs flash Red. And then move the left/right stick and left/right wheel to its maximum value in all direction, when all 3 LEDs stop flshing and there is a vibration from the remote controller, the remote controller calibration is completed.

Calibration value: If the stick/wheel value is not 50% in normal operation, please recalibrate the remote controller.

Get the version:After connect remote controller, click remote controller firmware version to get the firmware version.
固件升级-01
A. Receiver Upgrade
  • Connect the aircraft to PC through the USB cable provided.
  • Power on the aircraft, 4 LEDs in the aircraft will flash purple.
  • Click upgrade button on the Hornet 2 PC software.
  • If the value reaches 100% slowly, upgrade process is completed. Otherwise,it may mark sucess,actually it is not,please try again.
  • Disconnect the aircraft, power off the aircraft and reboot to finish upgrade process.

  • B. Receiver Upgrade
  • Connect the aircraft to PC through the USB cable provided.
  • Power on the aircraft, 4 LEDs in the aircraft will flash purple.
  • Click upgrade button on the Hornet 2 PC software.
  • If the value reaches 100% slowly, upgrade process is completed. Otherwise,it may mark sucess,actually it is not,please try again.
  • Disconnect the aircraft, power off the aircraft and reboot to finish upgrade process.
  • Notice: It is better to open PC device manager during upgrade process, you can see the driver from the libusb-win32 devices change to COM port, if it is not, please plug in the usb cable again, or you connect through the usb hub to change automatically. This can help to increase upgrade success rate.

  • C. Remote Controller Upgrade
  • Power on Remote Contoller
  • Connect the remote controller to PC through the USB cable provided.
  • Click upgrade button on the Hornet 2 PC software.
  • When the value reaches 100% and there is a vibration from remote controller, upgrade process is completed.

  • D. Wrist Controller Upgrade
  • Press one key to take off button and connect the wrist controller to PC through the USB cable provided.
  • Click upgrade button on the Hornet 2 PC software.
  • It will erase the data for the first time and it will begin to upgrade in the seconde time
  • When the value reaches 100%, upgrade process is completed.
  • 模块升级-01
    E. Wrist Controller Model Upgrade
  • Press take photo button and connect the wrist controller to PC through the USB cable provided.
  • Click connect button in aircraft parameter page.
  • Click upgrade button on the Hornet 2 PC software.
  • When the value reaches 100%, upgrade process is completed.
  •